973 228 164 · 699 147 762

Support Phone Number

Maintenance for sandwich panel roofs: what to check and how often

White sandwich panel cover

A sandwich panel roof needs little maintenance: two inspections a year, in spring and autumn, plus another one after every storm. What usually fails isn’t the panel itself, but the screws, flashings, sealants and gutters. With this checklist, you’ll have it under control.

Maintenance calendar

Task How often What to do
Clean gutters and downpipes Twice a year and after storms Remove leaves, mud and nests. A blocked gutter overflows and water gets in through the flashings.
Check screws Once a year Look for cracked washers or loose screws and replace them with new screws with EPDM washers.
Check flashings and seals Once a year Ridge, sides, and junctions with walls and chimneys. Reseal with butyl or polyurethane sealant.
Wash the sheet metal Every 1–2 years (every year near the sea or industrial areas) Water and mild soap with a soft brush, working top to bottom, then rinse.
Check the sheet metal Once a year Rust on cuts and edges, scratches or dents: sand gently and touch up with paint of the same RAL.
Rooflights Once a year Clean, check the fixings, and make sure the fall-protection mesh is in place.
Interior At the end of winter Damp patches or condensation drips: check the ventilation and the joints.

How to safely access the roof

  • Clip on to a lifeline with a harness.
  • Always step on the ribs (the line of screws) and on the low part of the corrugation, never in the middle of the span.
  • Never step on the rooflights: protect them with fall-protection mesh.
  • Soft-soled footwear free of stones. Never go up on the roof when it’s wet, frozen, or windy.

Signs that something’s wrong

  • Drips or stains near the line of screws.
  • Rust on panel cuts or on the flashings.
  • A loose flashing that rattles in the wind.
  • Standing water in the corrugations: insufficient slope or a blocked gutter.
  • Condensation dripping in winter: lack of ventilation or open joints.

If you already have leaks, follow the guide on waterproofing a sandwich panel roof, and if it’s dripping inside without rain, the one on condensation in roofing.

What not to do

  • Using solvents, bleach or abrasive products: they damage the paint.
  • Washing with high-pressure water near joints and flashings.
  • Sealing with acid silicone: it attacks the sheet metal. Use polyurethane sealant or neutral silicone.
  • Leaving drill shavings on the sheet metal: they rust and leave stains. Sweep up after every repair.
  • Resting ladders or loads directly on the corrugations.

Frequently asked questions

How often should a sandwich panel roof be inspected?

Twice a year, in spring and autumn, and always after a windstorm or hailstorm.

Can sandwich panels be painted?

Yes. For touch-ups, use paint for pre-lacquered sheet metal in the same RAL. To repaint the whole roof, clean it, degrease it and use a suitable primer for lacquered galvanized sheet metal. We explain it to you step by step in how to paint a sandwich panel.

Can it be cleaned with a pressure washer?

Yes, at low pressure, from a distance and without aiming at joints or flashings. Water and mild soap with a soft brush is a better option.

How long does a sandwich panel roof last with maintenance?

Decades. We explain this in how long a sandwich panel lasts.

Need replacement parts?

Screws, butyl, sealants and flashings: find them in screws for sandwich panels and sealing and weatherproofing. Request a quote or call us at 699 147 762.

PERSONALISED QUOTE

Receive a made-to-measure sandwich panel quote

Indicate dimensions, location, application and required service. The more data we have, the better we can adjust the panel, flashings, transport and installation.