The sandwich panel is a versatile, durable and efficient material that requires proper assembly to ensure optimum performance. Below, we explain the installation process step by step, accompanied by the corresponding images for a clear and effective guide.
1. PLATE ORIENTATION
The ribs of the sandwich panel should always be oriented in the direction of the slope. This facilitates the evacuation of rainwater, preventing accumulation problems and ensuring proper drainage.
2. MINIMUM SLOPE
It is essential to respect the minimum slope according to the type of panel:
- Flashing Panel: 5%.
- Roof Tile Panel: 10%.
- Sight Screws: 7%.
- Slate Panel: 30%.
These slopes ensure the correct functioning and performance of the material.
3. PLANNING THE STARTING SIDE OF THE ASSEMBLY
Before starting, note the bottom panel socket:
- Fix the initial piece with the lower nipple.
- Fit the plate into its “socket” and secure it with screws.
This will ensure accurate assembly and avoid errors during assembly.
4. CLEANING AND PROTECTION
During installation:
- Sanitize the edges of the sheet to eliminate burrs adhered by the cut.
- Remove dirt and residues from the surface to avoid rust stains or scratches.
- Cover exposed foam areas to improve aesthetics and prevent insects from entering.
- Remove the protective film as soon as possible to prevent the sun from hindering its removal.
5. FIXATIONS
Fasteners should be located at the top of the joint, avoiding drilling into the “water path”. In the case of systems with concealed fasteners:
- Fix the panel with screws.
- Install the snap-on cap, included with the panel, to cover the fasteners and maintain a clean finish.
6. COMPLETION OF THE INSTALLATION
Once the installation is completed:
- Verify that all joints are properly fastened and aligned.
- Make sure that the protective film has been completely removed.
- Performs a final visual inspection to ensure a professional finish.
Conclusion
By following these steps, you guarantee a correct and efficient installation of the sandwich panel. This process ensures the durability, aesthetics and functionality of the material in any project.
