973 228 164 · 699 147 762

Support Phone Number

Made to measure

Technical advice

Delivery to site

Specialist installation

SANDWICH PANEL · CONFIGURATION AND QUOTE

Cellular Polycarbonate – 6 mm Opal

Configure your panel

Select the available options. We will prepare the price based on dimensions, quantity, transport and installation.

PERSONALISED QUOTE

Request a price for this product

Tell us the panel type, area, thickness, location and whether you need supply only or installation. We’ll review the details to prepare a tailored proposal.

QUICK REQUEST

Tell us what you need

Complete the main details and we will prepare a proposal tailored to your project.

Description: Cellular Polycarbonate – 6 mm Opal

Description

Standard Cellular Polycarbonate Panels are polycarbonate sheets with honeycomb structures that provide the product with insulation and resistance. All polycarbonate sheets are protected from ultraviolet rays by co-extrusion of U.V. absorbers on the outer face.

Applications

  • Translucent tunnels
  • Skylights with structure
  • Replacement of window glass
  • greenhouses

Fastening system

The fastening system must allow the free expansion of the sheet, therefore rigid fastenings or fastenings with through bolts are not recommended. Always provide sufficient clearance between the bore and the screw.
Joint for 6 mm opal cellular polycarbonate with aluminium profile and cap, EPDM gaskets and screw between sheets
1 aluminium cap · 2 universal aluminium profile · 3 sheet · 4 screw · 5 sealing gasket · 6 base gasket (EPDM).

Structure

Whenever possible, ribs should be provided in the direction of the maximum slope of the sheet to ensure minimum dust accumulation in the cavities.

The sheets require a longitudinal and/or transversal support structure that can be of any nature or geometry. In the modulation, the maximum dimensions of the sheet must be respected according to its thickness and the loads to be supported, making them compatible with an adequate quartering.

Commissioning and handling

The sheets are protected by a film on both sides indicating which side is protected from solar radiation.

When it is necessary to seal the joints, the compatibility of the polycarbonate with the sealant must be ensured (neutral silicone is recommended).

It is essential to cover the cells to prevent dust from entering the interior of the sheet. Aluminum tape is recommended at the ends: smooth at the top and porous, allowing condensation water to drain out at the bottom.

If it is necessary to perforate the sheet, fastening buttons should be used.

Technical characteristics by thickness

Swipe the table

Thickness4 mm6 mm8 mm10 mm16 mm
Structure2W2W2W2W3W
Width (mm)2,1002,1002,1001,250 / 2,1001,250 / 2,100
Length (mm)6,0006,0006,0006,000 / 7,0006,000 / 7,000
Light transmission, clear (%)8280808062
Light transmission, ice (%)6460605535
Thermal transmittance U (W/m²·K)3.93.53.23.02.0
Sound insulation (dB)1415161921
Minimum bending radius (mm)7501,0001,2501,5002,400
Reaction to fireB-s1,d0B-s1,d0B-s1,d0B-s1,d0B-s1,d0

Download technical data sheet (PDF) ↓

ON-SITE SERVICE

Specialist team for sandwich panel installation

We quote for new builds, refurbishment, roof and facade replacement, flashing installation, and work with sheet metal or skylights.

The quote depends on geometry, height, access, auxiliary equipment, location, fixings and junctions the job must resolve.

Sandwich panel installation on site