973 228 164 · 699 147 762

Support Phone Number

Made to measure

Technical advice

Delivery to site

Specialist installation

SANDWICH PANEL · CONFIGURATION AND QUOTE

Mounting Accessory – Chimney Cap

Configure your panel

Select the available options. We will prepare the price based on dimensions, quantity, transport and installation.

PERSONALISED QUOTE

Request a price for this product

Tell us the panel type, area, thickness, location and whether you need supply only or installation. We’ll review the details to prepare a tailored proposal.

QUICK REQUEST

Tell us what you need

Complete the main details and we will prepare a proposal tailored to your project.

Description: Mounting Accessory – Chimney Cap

Sealing piece for taking pipes and flues through sandwich panel and metal sheet roofs. It is a flexible, stepped EPDM cone with an aluminium base that you shape by hand to fit the ribs. It is cut to the size of the pipe and seals around it without the need for special flashings.

Characteristics

UseChimneys, ventilation pipes, extractors and downpipes passing through the roof
MaterialEPDM cone and mouldable aluminium base
ResistanceOzone, UV and weather; does not age in the sun
TemperatureUp to about 100 °C in continuous use (guide value)
DiametersSeveral sizes depending on the pipe diameter: tell us the outside diameter
Suitable forSandwich panel roofs, profiled sheet and other roofs

How to install it

  1. Cut the hole in the panel, slightly larger than the pipe, and seal the exposed insulation edge.
  2. Cut the cone at the step that matches a diameter slightly smaller than the pipe (around 20% smaller), so it grips tightly.
  3. Slide the flashing down the pipe until the base sits on the panel; if it is tight, wet the pipe with soapy water.
  4. Shape the aluminium base to the ribs, run a bead of sealant underneath and fix it with flashing screws or rivets every 3–4 cm.

Tips

  • On profiled roofs, turn the base so one corner points towards the ridge: water is shed to the sides and does not pond behind the pipe.
  • If the pipe is from a wood stove or boiler, use insulated twin-wall flue where it passes through the roof.
  • Check the sealant and the base screws every few years.

Frequently asked questions

Is it suitable for a wood-stove chimney?

Yes, provided the flue passing through the roof is insulated twin-wall. A single-wall flue can exceed the temperature EPDM can withstand.

What size do I need?

It depends on the outside diameter of the pipe. Tell us and we will give you the size; each size covers a range of diameters.

See also all sandwich panel mounting accessories. Need a price? Ask for a quote or call us on +34 699 147 762 · WhatsApp.

ON-SITE SERVICE

Specialist team for sandwich panel installation

We quote for new builds, refurbishment, roof and facade replacement, flashing installation, and work with sheet metal or skylights.

The quote depends on geometry, height, access, auxiliary equipment, location, fixings and junctions the job must resolve.

Sandwich panel installation on site