973 228 164 · 699 147 762

Support Phone Number

Made to measure

Technical advice

Delivery to site

Specialist installation

SANDWICH PANEL · CONFIGURATION AND QUOTE

Sandwich Panel Screw – IPN Beam

Configure your panel

Select the available options. We will prepare the price based on dimensions, quantity, transport and installation.

PERSONALISED QUOTE

Request a price for this product

Tell us the panel type, area, thickness, location and whether you need supply only or installation. We’ll review the details to prepare a tailored proposal.

QUICK REQUEST

Tell us what you need

Complete the main details and we will prepare a proposal tailored to your project.

Description: Sandwich Panel Screw – IPN Beam

Self-drilling screw for fixing sandwich panels directly to I-beams (IPN, IPE) and thick steel sections up to 12 mm thick. Its long drill point finishes drilling the beam flange before the thread starts to engage, so no pre-drilling is needed.

Characteristics

TypeLong drill point self-drilling screw, hex head
SubstrateIPN and IPE beams and steel sections up to 12 mm
Pre-drillingNot needed
Socket10 mm
Drilling capacityUp to 12 mm of steel
Recommended speed1,000–1,500 rpm
MaterialCase-hardened steel, zinc-plated
SoldBy the unit

Sizes

Choose the length by adding the panel thickness at the fixing point and the thickness of the beam flange: the screw must pass through both and protrude at least three threads below. Tell us the panel thickness and the beam section and we will tell you the right size.

How to install it

Sandwich panel screw for IPN beams driven through the panel into the beam flange
Fixing diagram on an IPN beam.
  1. Mark the position of the beams on the panel so you screw right above the flange.
  2. On roofs, place the screw on the crown of the rib.
  3. Drive the screw square to the panel at 1,000–1,500 rpm, without hammer action and with steady pressure so the point drills the flange without overheating.
  4. Stop when the head is snug against the panel, without crushing it.

Tips

  • Do not speed up when drilling a thick flange: too much speed burns the point before it gets through the steel.
  • If the flange is thicker than 12 mm, pre-drill it or ask us about another fixing.
  • Clear metal swarf off the panel when you finish: if left on it, it rusts and stains the sheet.

Frequently asked questions

How is it different from the purlin screw?

The drill point. The I-beam screw has a longer point and drills up to 12 mm of steel; the purlin screw is designed for sections up to 6 mm.

Do I need to pre-drill the beam?

No, unless the flange is more than 12 mm thick.

See also: Sandwich Panel Screw – Tubes/Purlins · Sandwich Panel Screw – Wood · Sandwich Panel Screw – Concrete · Sandwich Panel Screw – Flashings · all our sandwich panel screws.

Need a price? Ask for a quote or call us on +34 699 147 762 · WhatsApp.

ON-SITE SERVICE

Specialist team for sandwich panel installation

We quote for new builds, refurbishment, roof and facade replacement, flashing installation, and work with sheet metal or skylights.

The quote depends on geometry, height, access, auxiliary equipment, location, fixings and junctions the job must resolve.

Sandwich panel installation on site